EDIS 36-1 trigger wheel mounting

Pulley is done after I put the missing tooth 90° ATDC instead of BTDC. Whoops!


The sharpie mark on the pulley is where the VR sensor sits, the keyway points toward the head at #1 TDC and the missing tooth is finally in the right spot.


The spacer ring thing was a bunch of JB Weld inside a tape “dam” around the circumference of the pulley, then turned down in the lathe to center the EDIS wheel. The wheel was then JB Welded in a few spots to secure it.

More later!

Leave a Reply